Z gap What is the proper z gap

The z-gap setting is quite important for optimum part adhesion to the printbed and clean part finish at the bottom surface.
It is a good idea to watch from the side and the top when the CubeX prints the first layer. Looking at the first layer print lines you can quickly see if your z-gap setting is ok.
The first layer should be a little smushed onto the print bed so you get good adhesion and no gaps between print lines.  A z-gap of just under 0.1mm should do that. Some use just a sheet of paper to check the z-gap.
If you print with ABS, you want your z-gap a little tighter, close to 0.05mm.
See the illustrations below:  (another CubeX user found them somewhere on the Cubify website, - thanks J. Andre!)

 

 

In general, this is what I do before printing:

1. Select the "Home" button. This will move the print jet behind the print bed so you can do step three.
2. Make sure the jets dont have any (not even a tiny piece at the tip) of filament left stuck on them otherwise it can affect your z-gap measurement.
3. Hit the "z-gap" menu button and check or adjust the z-gap with the up/down button.
4. Then print. 

Note: Always "Home" before setting or checking the z-gap. This has been most consistent.

 

 

 

See also Cubify website for z-gap setting suggestion.

http://cubify.com/blog/how-to-set-z-gap-on-the-cubex/